User's Manual

HYPER3™ IN-LINE REGULATOR

ADJUSTMENTS AND MAINTENANCE

HYPER3™ REGULATOR DIS-ASSEMBLY INSTRUCTIONS

To disassemble the Hyper3™ regulator you will need a C-clip tool or a strong pick. Remove the

C-clipfromthebottomoftheHyper3reg.Next,unscrewtheBrassseathousingfromthebody

with a 3⁄16” Allen key.

To change the seat, pull out the old seat from the housing with a sharp object. Insert the new seat

in place and push it down with a ﬂat object. Notice that it takes about 2000 shots for the seat to

perfectly sit into the seat housing. This is called the break in period for the regulator.

Remember to apply lube to the 010 on the brass reg seat housing before re-assembly.

Further disassembly to service the top section of the Hyper3™ should be performed by

a trained Tech.

011 BN 70C-CLIP

VELOCITY ADJUSTMENT

The velocity of the SLG™ is adjusted by adjusting the input

pressure into the SLG™. This is controlled with the Hyper3™

regulator. The Hyper3™ on the SLG™ is factory set to 145 psi which

will give you a velocity of about 285 FPS (Feet per Second).

⁄16” Allen key will be needed for this operation. Turning the

adjustment screw in (clockwise) will decrease the pressure, and

out (counterclockwise) will increase the pressure. To adjust the

velocity:

1. Make sure you and everybody around you is wearing ASTM/

CE approved paintball goggles.

2. Shoot the SLG™ over a paintball chronograph.

3. To lower the velocity turn the Hyper3™ adjustment screw in.

To increase the velocity turn the screw out. Only turn the screw

a quarter turn at a time and shoot over the chronograph again.

Notice that a few shots are needed before the change can be

seen on the chronograph.

MAINTENANCE

For the SLG™ to function properly, it is essential that the input

pressure into the marker stays consistent at all times. The general

maintenance needed for the Hyper3™ regulator is to keep it clean

ofdirtanddebrisatalltimes.Amoreextensiveserviceshould

be performed every 12 months by a trained Tech or if the output

pressure of the regulator doesn’t stay consistent. This can be seen

as inconsistent velocity and veriﬁed with a regulator tester (sold

separately). Notice that the Hyper3™ has a break in period of about

2000 shots before it achieves the best performance.

HYPER3™ IN-LINE REGULATOR

ADJUSTMENTS AND MAINTENANCE

W W W . P R O T O P A I N T B A L L . C O MW W W . P R O T O P A I N T B A L L . C O M

20 21

SEAT HOUSING REGULATOR SEAT BODY TOP CAP