User's Manual

TROUBLE SHOOTING GUIDE TROUBLE SHOOTING GUIDE
correct connector (the microswitch connector
is white and plugs into the white female
connector on the board).
• Change the battery if not positive about it’s
charge.
• Check that the solenoid cable is attached to
the blue female connector on the board.
TRIGGER BOUNCE / SLG™ SHOOTING MORE
THAN ONE BALL PER PULL IN SEMI AUTOMATIC
MODE
• Raise the trigger sensitivity level in the
configuration mode.
• Check that the trigger is not adjusted too short.
• Make sure there is a trigger spring inside the
frame.
• Be sure the bolt is screwed together snugly.
ERRATIC VELOCITY / SLG™ WON’T
FIRE
SLG™ FIRES BUT BALLS ARE DROPPING OFF OR
NOT EVEN COMING OUT OF THE BARREL
• Make sure the battery is good.
• Make sure bolt is clean, well lubed, and moves
well. If there is too much friction in the bolt it
will cause the SLG™ to shoot down.
• Make sure air system is screwed in all the way.
• Make sure airport screw is adjusted correctly.
• Make sure the front bumper O-ring is not
blocking the inlet hole located on the back
of the bolt.
OTHER CATEGORIES
DOUBLE FEEDING
• If you get two balls firing at once change the
ball detents by removing the eye plates, taking
out the old ball detents and inserting new ones.
BREAKING PAINT
• Make sure you use high quality paintballs and
that they are stored according to the
manufacturers instructions.
• Check that #14 O-ring on bolt tip is in place
and in good condition.
• Make sure your loader is working and that the
rate of fire is not set higher than the maximum
feed rate of the loader.
• Check that the barrel you are using is not too
tight for the paintballs you are using.
• Eyes are clean/on.
NOTES:SLG WILL NOT FIRE BUT SOLENOID CLICKS
• Press the bleed button on the back of the bolt
several times, listen for bolt moving rear wards.
If the bolt is still not moving, depressure the
SLG and remove back and bolt, add lube to the
bolt and reassemble.
FIRST SHOT IS TOO HIGH
• Change the Seat inside the Hyper3™ regulator.
For dis-assembly instructions consult the
technical section on page 21.
VELOCITY IS NOT CONSISTENT
• Make sure the paintballs you are using fit the
barrel good and are consistent in size.
The stock barrel with the SLG™ is .690 size.
You should be able to blow the paintball
through the barrel but they should not roll
through the barrel on their own.
• Remove the bolt kit and re-lube it. Change any
o-rings causing a lot of friction. Make sure
#014 O-ring in bolt tip is in place and in good
condition.
• Change the battery.
• Check that the Hyper3™ regulator is working
good and that the pressure is consistent.
A separate regulator testing tool is available for
this. If needed, dis-assemble and change worn
out O-rings in the Hyper3™ regulator.
W W W . P R O T O P A I N T B A L L . C O MW W W . P R O T O P A I N T B A L L . C O M
26
27