User's Manual

LOADERS AND FEED NECK
LOADERS AND FEED NECK
To achieve the maximum performance
of the SLG™ you will need to use a
motorized loader that force feeds
paintballs into the SLG™ marker. Using
a slower motorized loader or a non-
motorized loader will work, but the rate
of fire will be reduced.
To fit a loader onto the SLG™,
press the loader into the feed neck.
Loader should now be held in with a
snug fit.
There is no maintenance needed
for the feed neck besides
keeping it clean of broken
paint, dirt and debris.
If O-rings become worn
out they can be replaced
with 023 BN-70 O-rings.
AIR/NITROGEN
OPTIONS AND INSTALLATION
AIR / NITROGEN TANK
OPTIONS AND
INSTALLATION
The SLG™ will only work with
Compressed air or Nitrogen air
systems such as the DYE
Throttle air system. Do not use
CO
2
or any other compressed gas.
The output pressure from the air
system has to be between 400 –
850psi.
To install an air system, screw the
tank into the airport all the way as
far as it goes. To remove the air
system, unscrew from the airport.
There will be gas leaking for a few
seconds while you screw the air system
out. Notice that even with the air system
removed there can be gas inside the SLG™
and it can still fire a paintball. Always treat
the marker as being live and never point it to
anything you don’t intend to shoot.
W W W . P R O T O P A I N T B A L L . C O MW W W . P R O T O P A I N T B A L L . C O M
16
17