Owner manual

3
•
Disconnect the battery from the charger and carefully move the battery
to a fireproof location if the battery begins to swell or smoke!
•
Do not leave the charger unattended while charging. Disconnect the
battery and unplug the charger immediately if either becomes hot!
However, it is normal for the charger to get warm.
•
Never allow the battery temperature to exceed 140° F [60° C].
•
Never disassemble or modify pack wiring in any way or puncture cells.
•
Do not place the charger or any battery on a flammable surface or near
combustible materials while in use.
•
Never charge inside a vehicle.
•
Always disconnect the battery and remove the charger from the USB
port when not in use.
•
Do not attempt to charge a battery if it is swollen or hot.
•
Land your model immediately when the low-battery LEDs flash. Recharge
the battery before attempting another flight. A dangerous situation can
occur when attempting to recharge an over-discharged battery!
•
ALWAYS keep a supply of sand handy when charging. Dumping sand on
the battery will extinguish a LiPo chemical fire.
•
ALWAYS KEEP OUT OF REACH OF CHILDREN.
CARE AND MAINTENANCE
•
Always remove the batteries from the controller and the quadcopter
when it is not being used for a long period of time.
•
Clean the quadcopter with a damp cloth.
SAFETY CHECK
Before operation, please make sure the batteries for the controller and the
quadcopter have enough charge for flying.
❑
Carefully check the rotor blades for damage. Broken or premature parts
failure may result in a dangerous situation.
❑
Before turning on the controller, please check that the throttle stick is in the
lowest position.
❑
Always turn on the controller first, and then connect the battery to the
quadcopter to start flying.
❑
Always unplug the battery first and then turn off the controller after the
flight has ended.
❑
Beginners should find a large area free from obstacles (such as a
gymnasium or a large basement with a tall ceiling). If the winds are calm,
experienced pilots may also be able to fly the Proto-X SLT outdoors.
CONTROLLER
OFF
Elevator Trim
Throttle/Rudder Stick
Rudder Trim
LED Indicator
Throttle Trim
Elevator/Aileron Stick
Power Switch
Aileron Trim
INSTALL BATTERIES
1. Remove the screw 2. Take off the cover
PUSH
3. Install alkaline batteries
according to the
proper polarities
5. Re-install the screw 4. Re-install the cover
PUSH