™ CONTENTS S SPECIFICATIONS SPECIFICA CATIONS REQUIRES Proto-X SLT Nano Quadcopter pter USB Charge Cord LiPo Flight Battery 2.4GHz Controller Spare Blades (2 black, 2 gray) Siz Size: ize: Flying Flying Weight: Fl W Blade Length: Length: Height: Width: Battery: Flight Time: Four AAA 1.5V alkaline batteries USB Output Jack Phillips head screwdriver READ THROUGH THIS MANUAL BEFORE OPERATING. 1.97" [50mm] (distance between diagonal motors) 0.4 oz [11.1 g] 1.2" [30mm] 1.9" [48mm] 0.9" [23mm] 1.
Thank you for purchasing the Proto-X SLT Quadcopter. We are certain you will get many hours of enjoyment out of this model. If you should have any questions or concerns please feel free to contact us at Hobby Services. SAFETY PRECAUTIONS Follow these safety precautions when operating this or any model helicopter. • Adult supervision required. or modifications to this product not expressly approved by • Changes the party responsible for compliance may void the user’s authority to operate the equipment.
the battery from the charger and carefully move the battery • Disconnect to a fireproof location if the battery begins to swell or smoke! not leave the charger unattended while charging. Disconnect the • Do battery and unplug the charger immediately if either becomes hot! However, it is normal for the charger to get warm. • Never allow the battery temperature to exceed 140° F [60° C]. • Never disassemble or modify pack wiring in any way or puncture cells.
CHARGING THE FLIGHT BATTERY The quadcopter must be powered off before charging. When the battery voltage begins to run low, the LEDs on the quadcopter will flash. This is a warning to land before the built-in low-voltage cut-off reduces power to the motors. Plug the charger into a USB port on your computer or USB AC adapter and connect the quadcopter. The connector for the quad will only fit one way. Do NOT force the plug onto the connector at the back of the quadcopter.
FLIGHT TRIM ADJUSTMENT SENSITIVITY ADJUSTMENTS To adjust the sensitivity of the controls in the standard flight mode, press down the right stick and hold it until the display shows the letters SE. Release the right stick. IM T TR LEFT TRIM RIGHT TRIM M RI FT T H RIG LE Yaw/Rudder Sensitivity: Push down on the left stick quickly. There will be 3 dots flashing in the lower left corner of the display below the rudder trim graph. The default setting is 50%.
360° AERIAL FLIPS (Expert Mode Only) TROUBLESHOOTING Tip: Perform the flip while gaining altitude. PROBLEM: The quadcopter will not respond to the controller. SOLUTION: (1) Charge or change the battery on the quadcopter (2) Make sure that the throttle is at 0% and the throttle trim at or below center. (3) Turn off the quadcopter for a minute and turn it back on. (4) Relink the controller and quadcopter – See Linking the Quadcopter and Controller instructions on page 7.
SLT SETUP The Proto-X SLT Nano Quadcopter can be used with other SLT controllers. If your controller has programmable settings or if it uses an ANYLINK/ ANYLINK2 adapter, please use these settings as a guide to get started.
ESTE49** Mnl © 2014 Estes-Cox Corp. A subsidiary of Hobbico, Inc.
