User manual

CONFIDENTIAL Protium Technologies, Inc. 4050-9901
Rev No: 05
5 GHz RF Modem 31-Jan-2007 34 of 84
This document and information contained herein is subject to the restrictions set forth on the title page .
If one or more of the identifiers “rf”, “pa”, or “modem” is present the command
applies only to the specified subsystem(s). If none is specified, the command
applies to all subsystems.
An excessive temperature reading in the RF module, the power amplifier, or the
modem board will generate a system alarm condition. The factory set threshold
for the alarm is 50°C but this may be changed with this command.
4.2.46 testmode Test LEDs, Fans, Relays
Usage: testmode [<0|1|n|y|off|on>]
Authorization: Operator RW; Administrator RW
With no argument, display the current state of the test mode. Otherwise set the
test mode on or off as specified.
When the test mode is on, all the front and rear panel status LEDs will be turned
on, both fans will be turned on, and the alarm relay states will be inverted.
The operation of the modem will be unaffected. If it is operational it will
continue to operate when test mode is on. Note, however, that the inverted state
of the alarm relays may externally affect the operation of the modem.
4.2.47 timeserver Time Server
Usage: timeserver [<nn.nn.nn.nn|hostname.domain>]
Authorization: Operator RO; Administrator RW
With no value specified, display the current setting of the time server. Otherwise
set the time server to the specified value. The change will take effect when the
system is restarted.
The time server may be specified as a “dotted quad” IP address, or as a hostname
and domain.
When the system is started, it will attempt to contact the specified time server
using Network Time Protocol (NTP) in order to set the modem’s internal time
and date. An accurate time and date is optional and not necessary for the
modem’s operation but it may be useful for timestamping messages in various
system logs.
If the timeserver is not specified, or if the attempt to contact the timeserver is not
successful, the modem’s time and date starts at 00:00 on 1-Jan-1970.
4.2.48 txfreq Transmit Frequency
Usage: txfreq [ffff.f]
Authorization: Operator RO; Administrator RW
Display or set the transmit frequency.
With no argument, display the current transmit frequency.