User manual

CONFIDENTIAL Protium Technologies, Inc. 4050-9901
Rev No: 05
5 GHz RF Modem 31-Jan-2007 31 of 84
This document and information contained herein is subject to the restrictions set forth on the title page .
Authorization: Operator RW; Administrator RW
Display or set the enable for the EIA-530/232 data port request-to-send (RTS)
inputs. If no data sharer is present, this command is not usable.
With the data sharer, the currently selected port is a function of the RTS signals
on the two ports. For a port to contend for access, its RTS signal must be
enabled.
Without an argument, display the current RTS enable setting.
With an argument, sets the RTS enables to port a, port b, both ports, or neither
port as specified.
4.2.38 rxfreq Receive Frequency
Usage: rxfreq [ffff.f]
Authorization: Operator RO; Administrator RW
Display or set the receive frequency.
With no argument, display the current receive frequency.
With a numeric argument, set the frequency to “ffff.f” MHz. The frequency may
be specified in 0.1 MHz (100 KHz) steps. The minimum and maximum
frequency depends on the dash variation of the modem:
DASH MINIMUM MAXIMUM
-1 5140.0 MHz 5150.0 MHz
-2 5091.0 MHz 5101.0 MHz
4.2.39 sharer Data Sharer Available
Usage: sharer [<yes|no>]
Authorization: Operator RW; Administrator RW
Display or set whether a data sharer is present in the system.
Without an argument, display whether the sharer exists. This is generally
determined automatically when the system powers up.
With an argument, override the automatically determined value. This is only
intended for testing purposes and not for normal operation. Setting this to ‘no’
will be persistent and will override the automatic setting. Setting this to yes will
only override the automatic setting until the system is power cycled.
The setting should always be set to yes for normal operation.
4.2.40 sharerout Data Sharer Output Selection
Usage: sharerout [<both|selected>]
Authorization: Operator RW; Administrator RW