User manual
CONFIDENTIAL Protium Technologies, Inc. 4050-9901
Rev No: 05
5 GHz RF Modem 31-Jan-2007 23 of 84
This document and information contained herein is subject to the restrictions set forth on the title page
.
4.2.9 config Configuration
Usage: config
Authorization: Operator RO; Administrator RO
Show current configuration settings summary.
4.2.10 dash Dash Variation
Usage: dash [<1|2>]
Authorization: Operator RO; Administrator RW
Display or set “dash” variation.
There are two variations for the RF modem: one transmits on a higher frequency
and receives on a lower frequency, and the other is the opposite. A link consists
of one modem of each variation so that the receive frequency of each one can be
tuned to the transmit frequency of the other. These two variations are called
“dash one” and “dash two.”
A modem may be physically changed in the field from dash one to dash two, or
vice versa, by following a specified procedure. After physically changing the
modem, this command must be used to properly configure the software.
Note: this change requires opening the unit and may invalidate the warranty.
Please consult the factory before making this change.
With no argument, display the current dash number setting. With an argument of
“1” or “2” set the dash number as specified. When the dash number is changed, if
there are valid transmit and receive frequencies set, then the frequencies are
swapped so that the same frequencies are retained in their correct subbands.
4.2.11 delaccount Delete Login Account
Usage: delaccount name
Authorization: Operator N/A; Administrator RW
Delete the named login account. Deleted accounts can not be undeleted, however
they can be recreated although the password will be reset when the account is
created.
4.2.12 dhcp DHCP Enable
Usage: dhcp [<0|1>] [<n|y|off|on>]
Authorization: Operator RO; Administrator RW
With no argument displays the current DHCP enable setting. Otherwise sets the
DHCP enable to the specified value.
DHCP is a protocol that permits an Ethernet device to have its IP port
configuration set automatically. When DHCP is enabled, at startup the modem
will request IP configuration information from a DHCP server. If DHCP is