User manual

CONFIDENTIAL Protium Technologies, Inc. 4050-9901
Rev No: 05
5 GHz RF Modem 31-Jan-2007 22 of 84
This document and information contained herein is subject to the restrictions set forth on the title page .
4.2.4 alarms Display Alarms
Usage: alarms
Authorization: Operator RO; Administrator RO
Display alarm conditions, if any. Alarms that have been asserted since the last
time this command was issued but are now de-asserted will be marked as
“cleared.” This feature allows transient alarm condition to be “remembered” and
more easily identified.
4.2.5 apc Automatic Power Control
Usage: apc
Authorization: Operator N/A; Administrator RO
Display the APC on/off setting. Note: this setting is normally ‘off.’
4.2.6 channel Select Data Channel
Usage: channel [<serial|ethernet>]
Authorization: Operator RW; Administrator RW
With no argument, displays the current data channel. Otherwise sets the data
channel to the specified value.
The modem may carry either serial data or 10Base-T Ethernet data. A link speed
of 128 Kbps is automatically selected when Ethernet traffic is being carried.
4.2.7 clear Clear Screen
Usage: clear
Authorization: Operator RW; Administrator RW
Clear terminal screen.
4.2.8 clock Clock Mode
Usage: clock [<int|ext|loop>]
Authorization: Operator RW; Administrator RW
Display or set the clock mode.
The clock mode is only applicable to synchronous communications. The
synchronous transmit data may be aligned to a clock provided by the modem
(“internal” clock), by the Data terminal Equipmemt (DTE) (“external” clock), or
by the receiver (“looped-back” clock). The proper choice of clock mode depends
on the requirements of the DTE.
With no argument, display the current clock mode. With an argument, set the
clock mode to “int,” “ext,” or “loop.”