User Manual

Installation and Assembly
Tools Needed:
Pliers
Phillips head screwdriver
Flat head screwdriver
10mm / adjustable wrench
6mm hex wrench (included)
Parts Included In Box:
(1) Rubber Base Ring
(1) Base
(1) Front Guard
(1) Rear Guard
(1) Motor Assembly
(1) Fan Blade Assembly
(1) Spring
(1) Support Pole Assembly
1. Attach Rubber Base Ring (Item #16*) to outer edge of
Base (Item # 5*). Be sure ribbed side of Base Ring is
facing down.
2. Remove 5 screws from Flange on bottom of Lower
Support Pole (Item #13*).
3. Completely extend Upper Support Pole (Item #21*)
from Lower Support Pole and insert Spring into bottom
of Lower Support Pole.
4. Attach Support Pole Assembly to Base. Tighten
hardware using star pattern to insure a tight, uniform fit.
5. Stand assembly on Base, and press down Upper
Support Pole and then tighten Height Adjustment Knob
(Item #3*).
6. Attach Motor Support Assembly to Motor Assembly
(see Figure 18).
7. Place Motor Support into Upper Support Pole.
- Insert Pivot Bolt and tighten.
- Insert Tilt Adjustment Knob and tighten.
8. Remove 4 screws on motor, and attach the Rear Guard.
Tighten screws only after all 4 screws are reattached to
the motor.
9. Remove the screws on the Motor and attach the Rear
Guard onto groove in motor shaft, and replace screws
(See Figure 19).
10. Loosen the set screw on the back of the Fan Blade
Assembly and slide onto the motor shaft.
11. Position set screw over flat groove on motor shaft an
tighten set screw using 6mm hex wrench (included). Be
sure set screw is on the groove, and the front of Fan
Blade Assembly is flush with front of shaft before
tightening.
12. Attach Front Guard by first aligning the top hooks of
the Front Guard onto the top of the Rear Guard edge.
Work your way around the Guard, placing the Front
Guard hooks over the Rear Guard edge. If necessary,
use a flat head screwdriver to help pry the Front Guard
hooks over the Rear Guard edge. Continue until all
hooks are completely attached to the Rear Guard
edge.
NOTE: This model CAN NOT be wall mounted
* On Page 18
30” PEDESTAL FAN: PT-30P-DDF-A, PT-30P-DDF-AF
NEVER LEAVE A FAN
UNATTENDED WHILE
OPERATING OR WHILE
CONNECTED TO A POWER
SOURCE
© 2013, Pinnacle Products International, Inc. 17 HVF Air Circulator User’s Manual
Figure 19: Attaching Rear Guard to Motor
Rear Guard
Motor
Motor Assembly
Machine Screw
Pivot Bolt
Tilt
Adjustment
Knob
Motor Support
Assembly
Wing Nut
Nut
Upper Support Pole
Figure 18: Attaching Motor to Motor Support Assembly
Do NOT slide fan blade screw
beyond the groove on the shaft!
This will cause the fan blade to not spin properly
and can cause damage to your fan! Be sure that fan
shaft is flush with front of fan blade assembly.
CAUTION