Use and Care Manual

NEVER LEAVE HEATER UNATTENDED WHILE BURNING

OR WHILE CONNECTED TO A POWER SOURCE

Maintenance

FUEL FILTER:

The fuel ﬁlter should be cleaned at least twice per

heating season. Clean the ﬁlter by rinsing it in clean

K-1 Kerosene. Contaminated fuel could make cleaning

the fuel ﬁlter necessary immediately.

NOTE: To remove the lter from models turn lter 90º

counter-clockwise. See Figure 6.

SPARK PLUG:

Clean and re-gap every 600 hours of operation, or

replace as needed. After removing the spark plug, clean

the terminals with a wire brush. Re-gap the terminals to

0.140” (3.5mm) See Figure 7.

PHOTOCELL:

The photocell should be cleaned using a cotton swab

dipped in alcohol or water at least once per heating

season, or more depending on conditions. See Figure

NOZZLES:

Nozzles should be cleaned or replaced at least once

per heating season. Contaminated fuel could make

this necessary immediately. To clean dirt from nozzle,

blow compressed air through nozzle front. It may be

necessary to soak the nozzle in K-1 kerosene to loosen

any dirt particles. See Figure 9.

Figure 7

Ignitor Wire

Spark Plug

Gap (3.5 mm)

Burner Head

Photocell

Photocell lens

Photocell Wire

Figure 8

Figure 9

Nozzle

Nozzle Face

Burner Head

Dispenser

Figure 6

Fuel Filter

Fuel Line

Fuel Tank