Use and Care Manual

NEVER LEAVE HEATER UNATTENDED WHILE BURNING

OR WHILE CONNECTED TO A POWER SOURCE

MAINTENANCE

Long Term Storage:

1. Drain fuel through the drain bolt in the bottom of

the fuel tank.

2. To remove the drain bolt, unscrew counterclockise

(see Figure 4). A 6 mm hex key (not provided) is

required to unscrew the drain bolt.

3. Using a small amount of kerosene, rinse and swirl

the kerosene inside of the fuel tank, empty the

tank fully.

4. To replace the drain bolt; insert the drain head

fully into the drain hole and screw clockwise.

IMPORTANT: Never store leftover kerosene between seasons,

using old fuel can damage heater.

Service:

DO NOT TAMPER WITH THE UNIT. HAVE A

COMPETENT SERVICEMAN MAKE ANY NECESSARY

ADJUSTMENT OR REPAIRS.

Use only original equipment parts. The use of alternate

or third party components can cause unsafe operating

conditions and will void your warranty.

We suggest following a maintenance schedule as follows:

FUEL / FUEL TANK:

Flush tank every 200 hours of operation or as needed.

DO NOT ﬂush with water, use fresh K-1 kerosene only.

FAN BLADES:

Blades should be cleaned at least once per heating

season, depending on conditions. Remove all

accumulated dust and dirt with a damp cloth, taking

care not to bend any of the fan blades. Be sure the

blades are dry before re-starting the heater. For fan

assembly removal, see Figure 5.

Drain Bolt

Figure 4

TIP: To order OEM parts call (800) 641-6996

Figure 5

Fan Blade

Motor Shaft

Set Screw

Never service heater

while it is plugged

in or hot!

WARNING

Motor

Sirroco Fan