Use and Care Manual

NEVER LEAVE HEATER UNATTENDED WHILE BURNING

OR WHILE CONNECTED TO A POWER SOURCE

1. Insert axle through holes in wheel support.

2. Slide then spacer onto axle.

3. Slide wheel onto axle and hold in place with the axle

nuts. (See Figure 1).

4. Place heater on wheel support frame and line up holes

on the fuel tank lip.

5. Attach front handle with (4) long screws

(50 mm) and (4) nuts through the second and third

hole from the front on both sides of the tank lip and

wheel support frame and tighten firmly.

6. Insert (2) short screws (30 mm) through the first hole the

front of in the tank lip and tighten firmly. Make certain

all (6) screws are secure.

7. Attach rear handle with (4) long screws (50 mm) and (4)

nuts through the first and second hole from the rear on

both sides of the tank lip and wheel support frame and

tighten firmly.

8. Attach front guard with the included hardware.

ASSEMBLY INSTRUCTIONS

Models: 150T-SDR / 220T-SDR

Figure 1

Axle

Axle Nut

Spacer

Tire

Wheel Support Frame

Figure 2

Handle

Wheel Support Frame

Safety Guard

FEATURES

Control PanelShell

Wheel

Fuel Gauge Fuel Cap Fuel Tank Drain Bolt

Support Frame

Power Cord

Handle

Rear Guard