Use and Care Manual

© 2019 Pinnacle Climate Technologies, Inc. Silent Drive Forced Air Heater User’s Manual
NEVER LEAVE HEATER UNATTENDED WHILE BURNING
OR WHILE CONNECTED TO A POWER SOURCE
3
®
The products described in this manual are kerosene
direct-fired, forced air heaters. Kerosene forced air
heaters are primarily intended for use for temporary
heating of buildings under construction, alteration or
repair. Direct-fired means that all of the combustion
products of the heater enter the heated space. This
appliance is rated at 98% combustion efficiency, but
does produce small amounts of carbon monoxide.
Carbon monoxide is toxic. Humans can tolerate only
small amounts of carbon monoxide and so precautions
should be taken to provide proper ventilation. Failure
to provide proper ventilation in accordance with the
instructions in this manual can result in death.
People with breathing problems should consult a phy-
sician before using this heater.
Early signs of carbon monoxide poisoning resemble
the flu. Symptoms of improper ventilation / carbon
monoxide poisoning are:
Headache • Dizziness • Nausea • Dry Mouth Sore
Throat • Burning of Nose and Eyes
If you experience any of these symptoms:
GET FRESH AIR AT ONCE! Have your heater serviced
and check for proper ventilation. Some people are
more affected by carbon monoxide than others. These
include: pregnant women, those with heart or lung
problems, anemia or those under the influence of alco-
hol or at high altitudes.
Not For Indoor Use. Indoor use permitted only for the
temporary heating of buildings under construction,
alteration or repair!
Provide at least a three square foot (2,800 sq cm)
opening of outside air for every 100,000 Btu/Hr (29
kW) heater rating. Refer to “Ventilation” on page 6 for
further instructions.
SAFETY INFORMATION (CONT.)
ALWAYS use only the electrical power (voltage and
frequency) specified on the model plate of the heater.
ALWAYS use only three-prong, grounded outlet and
extension cord.
ALWAYS use only 14 AWG or better extension cord.
ALWAYS unplug the heater when not in use.
ALWAYS install the heater so that it is not directly exposed to
water spray, rain, dripping water, or wind.
NEVER use fuels such as gasoline, benzene, paint
thinners or other oil compounds in this heater.
NEVER refill the heater’s fuel tank while the heater is
operating or still hot. This heater is EXTREMELY HOT
while in operation.
NEVER block air inlet (rear) or air outlet (front).
NEVER use duct work in front or rear of heater.
NEVER move or handle heater while still hot.
NEVER transport heater with fuel in tank.
NEVER use with an external fuel tank.
Keep all combustible materials away from this heater.
Minimum Clearance From Combustibles
150T-SDR 220T-SDR
Top 4 ft. (122 cm) 4 ft. (122 cm)
Sides 4 ft. (122 cm) 4 ft. (122 cm)
Front 8 ft. (244 cm) 8 ft. (244 cm)
ALWAYS locate heater on a stable and level surface.
If your heater is equipped with a thermostat, once it is
plugged in, it can start at anytime in accordance with
the thermostat setting.
RISK OF ELECTRIC
SHOCK!
WARNING
RISK OF BURNS, FIRE
AND EXPLOSION!
WARNING
CAUTION! HOT WHILE
IN OPERATION.
DO NOT TOUCH.
KEEP CHILDREN, ANIMALS, CLOTHING AND
COMBUSTIBLES AWAY FROM HEATER.
WARNING
RISK OF INDOOR AIR
POLLUTION!
WARNING
CARBON MONOXIDE
POISONING MAY LEAD
TO DEATH!
DANGER