PTK-8519 625 DUO Touch AC Battery Charger Manual

USB POWER
5V/2.1A
AC
INPUT
VOLTAGE
SELECTOR
6
5
4321
T
emp
.
1
Set the right AC input voltage before
you connect the power cord, otherwise
it may cause explosion!
12
OPERATION PROGRAM
Ensure to connect the battery to balance port when charging LiPo, Lilon,
LiFe and LiHV battery under balance mode.
The following describes the action process of the charger, using a lithium
polymer battery charging program as an example.
1) Connecting power
You can attach the 625 directly to a 11-18V output power supply via the
XT60 input cable.
2) Connecting The Battery
Important!!! Before connecting a battery it is absolutely essential to
check one last time that you have set the parameters correctly. If the
settings are incorrect, the battery may be damaged, and could even burst
into flames or explode. To avoid short circuits between the banana plugs,
always connect the charge leads to the charger first, and only then to the
battery. Reverse the sequence when disconnecting the pack.
3) Balance Socket
The balance wire attached to the battery must be connected to the
charger with the negative marking. Take care to maintain correct polarity!
(See the wiring diagram below.)
2. Connection
WARNING:
Failure to connect as shown in this diagram will damage this charger.
To avoid short circuit between the charge lead always connect the
charge cable to the charger first, then connect the battery. Reverse the
sequence when disconnecting.