Specifications

90 Module 124: Protege GX Hardware Overview | Enclosures
Enclosures
Throughout the training so far, you will have seen how many of each module fits into our cabinets. Now we will
have a look at the cabinets and see how they fit together.
Enclosure Specifications
Medium
EN-ST-2828
Large
EN-ST-4133
Fatboy
EN-GPT_3850
Jumbo
EN-GPT-6150
Dimensions 280 x 280 x 85 410 x 335 x 95 388 x 508 x 170 610 x 508 x 170
Half Modules 1 1 2 4
Quarter Modules - 1 4 8
Transformers 1 1 2 4
Batteries 1 2 2 4
Gear Plates - -




Gear Plates
The medium and large enclosures are not able to take gear plates. These are standard enclosures which have
PCB installed in them using plastic push through stand-offs. Transformers are screwed in to the chassis.
The Fatboy and Jumbo enclosures use a system of gear plates for mounting. PCBs are mounted to the gear
plates, and cabling is hidden and fastened behind the gear plates. This creates a much tidier way to wire your
enclosures, and by layering gear plates allows more equipment to fit in an enclosure.
Gear plates come in top and bottom versions of half and quarter sizes. Bottom plates sit at the back of en
enclosure, top plates fit on top of bottom plates creating a second layer.
Transformers are mounted at the left and have a metal cover to keep them isolated from low voltage
components. Cable management fingers allow incoming cables to be bunched together neatly.