Specifications

Level One: Protege GX Installer Study Guide | August 2013 449
Module 131: Hardware Programming
A module update is required when...
 You change any settings on the expander
 You change any programming
 The Controller advises it is required via the health status
 All of the above
What does the Controller Wizard do?
 Adds a Controller
 Adds expanders, inputs, outputs, trouble inputs
 Links all of the associated records
 All of the above
What steps are required to use the Controller onboard reader ports?
 None. Door processing is enabled by default
 Assign a Reader Expander address in the Controller Configuration tab and select the lock outputs to
use
 Assign a Controller address in the Reader Expander Configuration tab and select the lock outputs to
use
 Turn DIP switch 4 on
What does it mean if an address is shown in red in the Auto- Addressing window?
 The address has been changed but not updated
 The address can't be changed using Auto-Addressing
 The address is outside the Controllers address space
 The address is at factory default of 254
Which of the following will generate a Controller Health Status message?
 A low battery on a power supply
 Failure to communicate
 When encryption is disabled
 All of the above