Specifications

392 Module 138: Programming Walkthrough | Testing the System
Badge Card 5 (Ike Cansalla) at the Showroom Entry door and enter PIN 5555.
 Was access granted?
 Did the Showroom door unlock and remain unlocked?
Badge Card 5 at the Showroom to Warehouse door.
 Was access denied?
Badge Card 3 (Whare Hausmann) at the Showroom to Warehouse door.
 Was access granted?
Badge Card 5 (Ike Cansalla) at the Showroom to Warehouse door again.
 Was access now granted?
Set the Controller time to 4:59pm on a Monday.
 After 60 seconds or less, did the Showroom door lock again?
Using the software, arm the Warehouse area.
 Did the area arm?
 Did the Nano Reader on Reader Expander 1 Port 2 (the Showroom to Warehouse door) start beeping?
 Did the Reader LED start flashing once the area armed?
Set the Controller time to 3:59pm on a Saturday.
 After 60 seconds or less, did the Showroom door lock?
Badge Card 5 (Ike Cansalla) at the Showroom to Warehouse door.
 Was access denied?
Badge Card 1 (Manny Jah) at the Showroom to Warehouse door.
 Was access granted?
Using the software, ensure that the Showroom, Warehouse and System areas are armed.
Open input CP1:1.
 Did a Report in Showroom … event get produced?
 Did the Bell output activate?
Open the tamper input on the PSU.
 Did a Report in System … event get produced?
Next Steps
If you've answered yes to 90% or more of these items, you're probably ready to sit the final assessment. If not,
continue practicing until you can.