Specifications

Level One: Protege GX Installer Study Guide | August 2013 391
Testing the System
Our last - and perhaps most important - task is testing the system. The following steps provide a good
indication of how your final practical assessment will be marked. Each item represents one mark.
Using the software, arm the Showroom area.
 Did the area arm?
 Did the MultiProx Reader on Reader Expander 1 Port 1 (the Showroom Entry door) start beeping?
 Was the exit delay 10 seconds?
 Was the beeping made up of a short beep every second?
 Did the Reader LED start flashing once the area armed?
Badge Card 1 (Manny Jah) at the Showroom Entry door (the MultiProx Reader on Reader Expander 1 Port 1).
Enter the PIN 1111 if required.
 Was a PIN required?
 Was the PIN 1111 accepted and access granted?
 Did the Showroom area disarm?
If the showroom area failed to disarm, manually disarm it now using the software.
Badge Card 1 (Manny Jah) at the Showroom Entry door again.
 Was access granted without requiring a PIN?
Badge Card 1 at the Showroom Entry door twice.
 Did the Showroom area begin to arm?
If the showroom area failed to arm, manually arm it now using the software.
Set the Controller time to 7:50am on a Monday.
Badge Card 3 (Whare Hausmann) at the Showroom Entry door.
 Was access denied?
Badge Card 5 (Ike Cansalla) at the Showroom Entry door.
 Was access denied?
Set the Controller time to 7:59am on a Monday.
 After 60 seconds or less, did the Office Hours Schedule become valid?
 Did the Showroom door remain locked?