Specifications

Level One: Protege GX Installer Study Guide | August 2013 387
7. Configure Inputs
 Name the inputs and set them up as required:
Input Description Input Description
CP1:1 Showroom (PIR) RD1:1 Showroom Door (Reed)
CP1:2 Warehouse NW (PIR) RD1:2 Showroom Door (REX)
CP1:3 Warehouse NE (PIR) RD1:3 Showroom Door (Bond)
CP1:4 Warehouse SW (PIR) RD1:4 -
CP1:5 Warehouse SE (PIR) RD1:5 Showroom to Warehouse Door (Reed)
CP1:6 Warehouse Roller (Reed) RD1:6 Showroom to Warehouse Door (REX)
CP1:7 - RD1:7 Showroom to Warehouse Door (Bond)
CP1:8 - RD1:8 -
 Wire them so they are closed. Ensure the EOL values are set to match the wiring.
 Set the response time of the REX inputs to 50ms.
 Set the PIR and Reed inputs to use the Instant type.
 Assign the inputs to the appropriate areas.
8. Create a Door Type for the Showroom
 Create a new Showroom door type
 Set the operating schedule to the Showroom Door schedule
 Set the secondary mode to Card Only
 Set the primary mode to Card and PIN
9. Configure the Doors
 Name both doors for easy identification.
 Set the Showroom door to use the new Showroom door type.
 Set the unlock schedule to opening hours.
 Set the area inside for both doors.
 Set the Door Lock follows... and Area disarmed AND… options for the Showroom door.
10. Setup Auto Disarming
 Configure the Reader Expander so that both doors automatically disarm their area on valid access.