Specifications

324 Module 135: Configuring Intruder and Access Integration | Configuring Office Access
Door Type Integration Summary
1. We've created a new 24/7 Office Area Armed schedule that is qualified by the Keypad Red LED
This Schedule becomes valid whenever the Office area is Armed
2. We've created a new Door Type that has the new schedule as its Operating Schedule
3. We've set the Entry Mode to Card and PIN
4. We've set the Secondary Door Type to Card
5. We've assigned the new door type to the Office Entry door
This means that now:
 When the Office area is armed, the door type follows its primary settings (Card and PIN)
 When the Office area is disarmed, the door type switches to its secondary type (Card only)
Door Unlocking by Schedule
Earlier, we set the Office Entry door to unlock via the Office Hours schedule. Let's test this functionality:
 Set the Controller time to 4:59pm - at 5:00pm, the door locks.
 Arm the Office area by double badging at the Office Entry reader - the building is locked and secure.
But what happens if nobody turns up for work in the morning?
 Set the Controller time to 8:59am
At 9:00am, the door unlocks!
We need a way to prevent the Office Entry door from unlocking if the Office Area is armed. There are several
ways to achieve this, but we'll use the easiest approach:
 Navigate to Programming | Doors
 Select the Office Entry door and go to the Options tab
 Enable the following options:
 Door Lock Follows Inside Area
 Area Disarmed AND Schedule Valid Unlock Door