Specifications

318 Module 135: Configuring Intruder and Access Integration | Configuring Office Access
Configuring Office Access
From the Protege GX user interface:
 Set the Controller time to 7am on a weekday
 Arm the Office area (if it isn't already armed)
 Lock the Office Entry door (if it isn't already locked)
Now we're going to simulate the manager arriving in the morning:
 Badge Card 2 at the Office Entry reader and enter the PIN 9998
 Open the Office Entry Dr (Door) TXS CP1:1 input to simulate opening the door
 Note the keypad starts entry delay
Door Areas
It makes sense that if a staff member is allowed access, the area should be turned off automatically for them.
We'll do this now...
The first step to configure this is to assign the area to the door:
 Navigate to Programming | Doors
 Select the Office Entry door and go to the General tab
 Set the Area Inside Door to the Office area
Disarm On Entry
 Navigate to Expanders | Reader Expanders and select RD1
 Go to the Reader 1 tab and select (enable) the Disarm Area For Door On Access option
 Save the changes