Specifications

276 Module 133: Basic Intruder Detection | Programming Inputs
Set the Input Speeds
Now that we have configured our areas, let's look at other ways to use the Find tool.
1. Click Find and type (REX) into the label field.
2. Click Ok. You should get a list of two inputs:
3. Click on one of the inputs, then press CTRL + A to select all.
4. On the General tab, set the input speeds to 50 msec and click Save.
The default Input Speed is 500 msec. This means the input needs to be activated for half a second before it will
trigger. This can be too slow for a Request to Exit button
Common Searches Using the Find Tool
There are some other common searches we can use:
 TXS : This will list all inputs belonging to the Texas site
 TXS RD1 : This will list all inputs on Reader Expander 1 at the Texas site
These can be useful where EOL resistance needs to be set for a whole site or an entire expander.
To quickly find an available input when adding a new device, the find tool can be used with the word Spare.