Specifications
224 Module 131: Hardware Programming | Troubleshooting Hardware
Confirm the Event Server IP Address
For messages to get from the Controller to the Server, the Event Server IP address must be programmed
correctly
Open a command prompt at the Server and type ipconfigthen press [Enter]
If the Server has more than one IP address, select the one that is on the same sub network as the
Controller. In this case, 192.168.10.100
The Event Server will accept events on any IP network interface as long as the appropriate port is open
(22000 by default)
Now check that the Event Server IP is set correctly at the Controller
This is configured in the web interface for the DIN Controller or via Telnet for the PCB Controller: