Specifications

Level One: Protege GX Installer Study Guide | August 2013 137
PCB Controller Setup
To get a PCB Controller online with your Protege GX Server, there are a number of things that need to be set
up.
Firstly, the Controller needs to have an appropriate IP address, subnet mask and gateway (if applicable)
assigned. The PCB Controller has a factory default IP address of 192.168.1.2 and this should be changed to
suit the IP addressing scheme of your site. The IP address can be changed using the keypad, or using Telnet.
Assigning an IP Address via the Web Interface
If the current IP address is known, use the built in web interface to enter the details. This method can only be
used if the IP address is known.
1. With the Controller connected to your network, type the IP address into the address bar of your browser.
The default IP address is 192.168.1.2
2. A login screen appears. Enter a valid Installer Code. The default is 000000.
3. Click the Network link. The Network Configuration screen is displayed
4. Enter the required settings, and click save.
5. Click the System link. The Controller serial number is shown here. Note this down, as you will need it to
connect later.
Once finished, you must restart the Controller for the changes to take effect. This can be done by cycling power
to the Controller, using Telnet, or via the keypad.
Assigning an IP Address via the Keypad
1. The Protege GX PCB Controller comes programmed with a default installer PIN of 000000. Login to the
system by entering this code into the keypad.
ProtegeGX
ByICT
Enteruser
code:******
GoodMorning
Installer
2. Press [Menu] [4] [2] [1] to display the current IP address
*MainMenu*
4.Install
*InstallMenu*
2.IPconfig
*IPMenu*
1.View/EditIP
3. Edit the address using the numeric and [LEFT] [RIGHT] keys
IPAddress
192.168.001.002
IPAddress
192.168.001.003
4. Press the [ARM] key to save your changes
Press[ENTER]
toacknowledge
5. You'll be prompted to confirm your changes. Press the [ENTER] key to acknowledge. If you press any other
key, your changes will be discarded.