Specifications

Level One: Protege GX Installer Study Guide | August 2013 135
Assigning the IP Address from a Keypad
If the current IP address of the Controller is not known, it can be viewed and/or changed using a PRT-KLCD
keypad.
1. Connect the keypad to the module network.
2. Log in to the keypad using any valid Installer code. The default Installer code is 000000.
If the default code has been overridden and you do not know the new codes, you will need to force the
Controller into its default state. This is achieved by connecting Reader 2 D0 to Reader 2 L and power
cycling the unit. Note that this will erase all existing programming as well as setting up the default Installer
code.
3. Once logged in press [Menu] [4] [2] [1] to display the current IP address
*MainMenu*
4.Install
*InstallMenu*
2.IPconfig
*IPMenu*
1.View/EditIP
4. Edit the address using the numeric and [LEFT] [RIGHT] keys
IPAddress
192.168.001.002
IPAddress
192.168.001.003
5. Press the [ARM] key to save your changes
Press[ENTER]
toacknowledge
6. You'll be prompted to confirm your changes. Press the [ENTER] key to acknowledge. If you press any other
key, your changes will be discarded.
7. Go back to the View/Edit IP menu by pressing [ENTER] or [1]. Press the [UP] key to change the subnet
mask (if required).
NetMask
255.255.255.000
By default, the PCB Controller comes with a 24 bit class C subnet mask already set.
8. Press the [UP] key again, to display the Gateway address.
Gateway
192.168.001.001
This should be changed if your server is not on the same subnet, or if you are using an NTP server on
another subnet, and should be set to the IP address of your network's router.
Once finished, you must restart the Controller for the changes to take effect.
Restarting the Controller
There are three methods to restart the Controller:
1. Cycling the power
2. Using the web interface and clicking the Restart link
3. Using the keypad and selecting [Menu] [4] [2] [2]