Specifications

108 Module 127: Protege DIN Rail Hardware Configuration | DIN Rail Hardware Setup
DIN Rail Hardware Setup
The Protege System is an advanced technology security system designed to provide integration with building
automation, apartment complex control and HVAC in one flexible package. Communication is over a proprietary
high speed protocol across an AES encrypted local area network and an encrypted proprietary RS-485 module
network. Using modular-based hardware design, system installers have the flexibility to accommodate any
installation whether it's small, large, residential or commercial.
Flexible module network architecture allows large numbers of modules to be connected to the RS-485 Module
Network. Up to 250 modules can be connected to the Protege System in any combination to the network up to
a distance of 900M (3000ft). Communication beyond this distance requires the use of a RS-485 Network
Extender
Mounting
The Protege DIN Rail range is supplied as DIN Rail mount modules and are designed to mount on standard DIN
Rail either in dedicated DIN cabinets, Protege Jumbo Cabinet Enclosure with DIN Rail Gear Plates, or generic
DIN Rail mounting strip. A section of this DIN Rail strip is provided as a mounting option.
When installing the DIN Rail module ensure that there is adequate clearance around all sides of the enclosure
and air flow to the vents of the unit is not restricted. It is recommended to install the unit in a location that will
facilitate easy access for wiring. It is also recommended that the unit is installed in electrical rooms,
communication equipment rooms, closets or in an accessible area of the ceiling.
1. Hook the lower tabs under the bottom edge of the DIN Rail.
2. Push the unit against the DIN Rail mount and press firmly on the top center of the Controller until the upper
tab clips over the upper rail.
To reduce the risk of damage caused by debris during the installation, install the cabinet enclosure when the
unit is not installed on the rails.
Removal
The unit can be removed from the DIN Rail mount using the following steps:
1. Insert a flat blade screwdriver into the hole in the white tab at the top center of the Controller.
2. Lever the tab up and rotate the unit off the DIN Rail mount.