Specifications

88 PRT-WX-DIN Using Protege WX Installation and Programming Manual | June 2013
Expanders
The Expanders menu contains the settings required to connect and configure the various expander modules
available that extend your Protege WX system.
This Option: Is Used To:
Keypads Configure the keypads attached to your system
Analog Expanders Configure the analog expanders used to connect industrial automation devices
to your Protege WX system
Input Expanders Configure the input expanders used to extend the number of inputs available
within the system
Output Expanders Configure the output expanders used to extend the number of outputs available
within the system
Reader Expanders Configure the reader expanders used to extend the number of reading devices
and locking inputs available within the system
Expander Addressing View the hardware that is connected to the system network, and set the
addresses of the modules that have auto-addressing capability
Keypads
Keypads are used for all functions within the Protege System and are typically located near an entrance or door
to allow areas within the system to be armed and disarmed.
General
 Name: The name of the keypad
 Physical Address: The network address of the keypad.
Keypads | Configuration
 Area this LCD belongs to: The primary area for the keypad is the area that the keypad will display first on
all area display modes. The primary area should be belong to the keypad's area group, if any area actions
are to be performed on the keypad.
 Door Connected to Keypad: The door which is connected to the keypad.
 Area Group for this Keypad: Users can only access an area assigned to the keypad if the same area is
also assigned to the user's arm and/or disarm area group.