Specifications

PRT-WX-DIN Using Protege WX Installation and Programming Manual | June 2013
83
 Switch Secondary IP Immediately: When enabled the service will immediately use the secondary IP
settings.
 Report Open: When enabled the service will report opens (Disarming) for the areas that are part of the area
group assigned. An area group of none will mean ALL areas will be sent using this service.
 Report Close: When enabled the service will report closes (Arming) for the areas that are part of the area
group assigned. An area group of none will mean ALL areas will be sent using this service.
 Report Alarms: When enabled the service will report alarms for the inputs that are part of the area group
assigned. An area group of none will mean ALL areas will be sent using this service.
 Report Tampers: When enabled the service will report tampers for the inputs that are part of the area
group assigned. An area group of none will mean ALL areas will be sent using this service.
 Report Restore: When enabled the service will report restores for the inputs that are part of the area group
assigned. An area group of none will mean ALL areas will be sent using this service.
 Report Bypass: When enabled the service will report bypass's for the inputs that are part of the area group
assigned. An area group of none will mean ALL areas will be sent using this service.
 Log Acknowledge Response: When enabled the service will log acknowledge communication events.
 Log Polling Message: When enabled the service will log and event when the polling has been accepted by
the remote host receiver.
 Log Message Retires: When enabled the service will log a communications retry that occurs because of a
network failure or loss of service.
 Log Reporting Failure: When enabled the service will log an event when communications have failed
completely and the service is waiting on another attempt.