Specifications
PRT-WX-DIN Using Protege WX Installation and Programming Manual | June 2013
79
Contact ID | Options
Use Alternate Dialing Method: When enabled the service will switch between phone numbers 1 and 2 if a
connection cannot be made. If the first phone number fails, the service will switch to the second phone
number and vice versa until the max number of attempts is reached.
Pause After PABX: When enabled the dialer will insert a pause of 2.5 seconds after the PABX telephone
number is dialed.
Report Open: When enabled the service will report opens (Disarming) for the areas that are part of the area
group assigned. An area group of none will mean ALL areas will be sent using this service.
Report Close: When enabled the service will report closes (Arming) for the areas that are part of the area
group assigned. An area group of none will mean ALL areas will be sent using this service.
Report Alarms: When enabled the service will report alarms for the inputs that are part of the area group
assigned. An area group of none will mean ALL areas will be sent using this service.
Report Tampers: When enabled the service will report tampers for the inputs that are part of the area
group assigned. An area group of none will mean ALL areas will be sent using this service.
Report Restore: When enabled the service will report restores for the inputs that are part of the area group
assigned. An area group of none will mean ALL areas will be sent using this service.
Report Bypass: When enabled the service will report bypasses for the inputs that are part of the area
group assigned. An area group of none will mean ALL areas will be sent using this service.
Service Operates as Backup: When enabled the service will NOT report messages and alarms unless it is
started by another service that has failed. It will then start reporting messages immediately from the point
that the service that started it failed to report and then return operation to the service that started. This cycle
will continue until the service that failed operates normally.
Log Modem Events to Event Buffer: When enabled the service will provide step by step event information
showing the call progression and detailed logging information. This option can be turned on for diagnostic
purposes but should not be enabled permanently as large volumes of events are stored.