Specifications

38 PRT-WX-DIN Using Protege WX Installation and Programming Manual | June 2013
Status Indicator
The Status indicator displays the status of the Controller.
State Description
Flashing (green) at 1 second intervals The Controller is operating normally
Fault Indicator
The Fault indicator is lit any time the Controller is operating in a non-standard mode. During normal operation
the fault indicator is off.
State Description
Off Controller is operating normally
On (red) Controller is operating in a non-standard mode
Ethernet Link Indicator
The Ethernet indicator shows the status of the Ethernet connection.
State Description
On (green)
Valid link with a hub, switch or direct connection to a personal
computer detected
Flashing (green) Data is being received or transmitted
Off Ethernet cable not connected, no link detected
Modem Indicator
The Modem indicator shows the status of the onboard modem.
State Description
On (green) Modem has control of telephone line
Off Modem is not active
Reader Data Indicators
The R1 and R2 indicators display the status of the data being received by the onboard readers.
State Description
Short (red) flash
A SHORT flash (<250 Milliseconds) will show that data was received
but was not in the correct format.
Long (red) flash
A LONG flash (>1 Second) indicates that the unit has read the data
and the format was correct.