Specifications

18 PRT-WX-DIN Using Protege WX Installation and Programming Manual | June 2013
i
Inputs 1-4 (Door 1) and 5-8 (Door 2) can operate as either general purpose inputs or as onboard
reader inputs. If used as general purpose inputs you must ensure that they are not defined in the
onboard reader set up.
Each input can use a different configuration.
When using the No Resistor configuration, the Controller only monitors the opened and closed state of the
connected input device generating the alarm and seal conditions.
N.C Input Contact
V+
V-Z4 V- Z3 Z2 V- Z1
No EOL Resistor Input Configuration
Resistor Value Options
When using the EOL resistor configuration, the EOL resistor option must be configured based on the site
requirements.
Value 1 Value 2 Monitored Status
1k 1k Open, Closed, Tamper, Short
1k No Resistor Open, Closed
<5K7 No Resistor Open, Closed
No Resistor No Resistor Open, Closed
2k2 6k8 Open, Closed, Tamper, Short
10k 10k Open, Closed, Tamper, Short
2k2 2k2 Open, Closed, Tamper, Short
4k7 2k2 Open, Closed, Tamper, Short
4k7 4k7 Open, Closed, Tamper, Short