Specifications

Using the USB Pen Drive to Write Default Settings with the Test Station Software 41
SCOTT SAFETY 087-0048 REV B
Using the USB Pen
Drive to Write Default
Settings with the Test
Station Software
This section describes using the USB Pen Drive with the Test Station Software to
WRITE the settings.
1 Insert the USB Pen Drive into your PC’s USB port. After hardware is found the
Drive Dialog Box appears.Close the Drive Dialog Box.
2 Open the Test Station Software.
3 Ensure the USB DISK is selected and click WRITE. A successful connection
results in a Green bar in the lower right hand corner. See Figure 31.
Figure 31 USB Disk Write
4 The settings are written for the Test Station, Protege ZM and the Logs.
Additionally, the USB Pen Drive can be used to access the Event Logs and Test
Records directly. This allows remote access and verification of the files. See
“Retrieving Event Logs and Test Records Using the USB Pen Drive” on page 61.