Specifications

40 CHAPTER 4: CONFIGURATION AND SETUP
087-0048 REV B SCOTT SAFETY
Using the USB Pen
Drive to Read Default
Settings with the Test
Station Software
This section describes using the USB Pen Drive with the Test Station Software to
READ the defaults.
1 Insert the USB Pen Drive into your PC’s USB port. After hardware is found the
Drive Dialog Box appears.Close the Drive Dialog Box.
2 Open the Test Station Software.
3 Ensure the USB DISK is selected and click READ. A successful connection
results in a Green bar in the lower right hand corner. See Figure 30.
Figure 30 USB Disk Read
4 The defaults are restored for the Test Station, Protege ZM and the Logs.