Specifications

26 CHAPTER 4: CONFIGURATION AND SETUP
087-0048 REV B SCOTT SAFETY
Connecting the
Monitor to a PC
This section describes connecting the monitor to a PC.
The purpose of this hardware configuration is to configure one monitor at a time.
Required items:
This assumes you have already installed the IR Connect Software.
• The monitor
• The IR Connect and its USB Cable
• A PC
• IR Connect Software installed
1 Plug the USB Cable into the PC USB port and the other end into the IR Connect.
2 With the monitor powered on, place it face up or face down, within 1” to 2” in
front of the IR Connect. Ensure the two IR ports have a direct line of sight. See
Figure 18.
When face down, ensure monitor is level, or it will not be able to communicate with
the IR Connect. When face up, check for the Infrared Data Transfer Icon to appear.
This confirms communication between the monitor and the IR Connect.
Figure 18 Connecting the IR Connect to a PC
3 Click on the IR Connect Software icon on the desktop. The monitor is ready for a
READ DEVICE command.
4 Then click READ DEVICE. If the read was successful, a Green Bar at the bottom
of the screen appears. See Figure 19.
1” to 2”
Max.