Specifications

20 CHAPTER 3: INSTALLATION
087-0048 REV B SCOTT SAFETY
Figure 13 IR Connect Software Successful Installation
Installing the Test
Station Software
This section describes the installation of the Test Station Software.
The Test Station Software enables you to:
• Set Test Station parameters (used to configure multiple monitors placed in the Test
Station)
• Upgrade the Firmware on the monitors (placed in the Test Station)
• Retrieve Monitor Event Logs
• Retrieve Test Logs
PC System Requirements:
• USB port with up-to-date drivers installed
• Operating System (OS) as noted. See “Supported Operating Systems” on page 12.
.NET Framework Software must be installed to install the Test Station Software.
Please use Windows Update to check for any critical updates to the .NET Framework.
The Test Station Software may be used with either the Test Station or the USB Pen
Drive.
Depending on your needs, select either the setup.exe or setup.msi file. Consult with
your IT Administrator.