Specifications

16 CHAPTER 3: INSTALLATION
087-0048 REV B SCOTT SAFETY
Figure 7 .NET Framework Software Installation (4 of 4)
5 Double click on the Test Station desktop Shortcut to launch the application.
Installing the IR
Connect Software
This section describes the installation of the IR Connect Software.
The IR Connect Software enables you to:
• Set monitor parameters
• Upgrade the Firmware on the monitor
• Place monitor in Hibernate mode (for applicable devices)
PC System Requirements:
• USB port with up-to-date drivers installed
• Operating System (OS) as noted. See “Supported Operating Systems” on page 12.
For Windows Vista, perform step 2 prior to beginning installation. For Windows 7
proceed to step 3. For Windows XP proceed to step 4.
1 Prior to installing a higher version of the software, ensure the lower version is
removed. To remove lower version, select Start > Control Panel > Add or Remove
Programs > Scott Safety IR Connect Un-install > Remove.
2 For Windows Vista OS, navigate to USER ACCOUNTS AND FAMILY SAFETY
using the control panel and proceed to remove USER ACCOUNT CONTROL
(UAC). The check box must be unchecked for UAC. Restart the PC as necessary.
See Figure 8.