Specifications

78 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Arming Mode Operation
ENTRY Reader The reader is located on the outside of the door and is used to enter in to the area that is
being protected by the door. This is the default setting and should be set for all general
access doors (single reader)
EXIT Reader The reader is located on the inside of the door and is used to exit out of the area that is
being protected by the door.
If the reader expander is configured for multiplex reader mode the multiplexed reader is
ALWAYS the EXIT reader.
Reader Port 2 Keypad Operation Mode
The keypad operation mode programmed for the reader on port two determines if the reader port has a pin
entry device attached or uses a local LCD keypad.
RD001 R2 Key Mod
None
Use the [1] and [3] keys to scroll the available keypad mode settings. For more information about the list control
data entry refer to the section List Control Data Entry (see page 335).
i
When a Wiegand 26 Bit Keypad is used PIN numbers that are prefixed with a 0 can not be used and
the maximum pin number is limited to 65533. This is a limitation of the 26 Bit Format and not the
Reader Expander. To utilize the full 8 digit capacity for the PIN number of a user and allow prefixed
PIN numbers select a PIN device that supports the ARK-501 or 4 Bit Output Formats.
Reader Port 2 LCD Keypad
If the keypad operation mode is set to use one of the selected LCD keypads you can program the address of
the keypad to use for pin entry. When using this mode of operation the LCD keypad will present a login
message when a valid card is presented that requires pin entry.
RD001 R2 Keypad
None
Use the [1] and [3] keys to scroll the available keypad mode settings. For more information about the list control
data entry refer to the section List Control Data Entry (see page 335).
Reader Port 2 Multi Badge Operation
The reader port can perform various operations when a user badges their card multiple times. The list below
details the modes this can operate in.
When a multi badge operation has taken place the reader expander will beep the buzzer output four times. In
area control, if the area is already armed the reader will only beep twice.
RD001 R2 Badge
None
Use the [1] and [3] keys to scroll the available arming operation settings. For more information about the list
control data entry refer to the section List Control Data Entry (see page 335).