Specifications
36 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Use the [1] and [3] keys to scroll the secondary area group selection and press [ENTER] to select the area
group displayed. For more information about the list control data entry refer to the section List Control Data
Entry (see page 335). Programming a secondary area group that uses the current area group being edited will
perform no function.
Area Group Assignment Blocks 1 to 32
The area group assignment blocks assign an area to the group that is being programmed. Each block is 8 areas
and the number of area blocks depends on the number of areas that the system is configured to manage. For
example if there are 32 areas there will be 4 blocks of 8 areas. Block 1 option 1 will refer to Area 001 and Block
4 Option 8 will refer to Area 008.
AG001 Block 1
[12345678]
To modify the block setting options, follow the settings as explained in section Entering Data Options (see page
336). Use the relevant key from 1 to 8 to toggle the state of the option.
Pressing the [ENTER] key will move you to the next block in the area group until you return to the area group
selection.
The following table shows the relationship between the block and the area that is being selected for the area
group. For example if you want to select Area 23 you would go to block 3 and then change the 7 option.
Block
#
Opt
1
Opt
2
Opt
3
Opt
4
Opt
5
Opt
6
Opt
7
Opt
8
1 Area
001
Area
002
Area
003
Area
004
Area
005
Area
006
Area
007
Area
008
2 Area
009
Area
010
Area
011
Area
012
Area
013
Area
014
Area
015
Area
016
3 Area
017
Area
018
Area
019
Area
020
Area
021
Area
022
Area
023
Area
024
4 Area
025
Area
026
Area
027
Area
028
Area
029
Area
030
Area
031
Area
032
5 Area
033
Area
034
Area
035
Area
036
Area
037
Area
038
Area
039
Area
040
6 Area
041
Area
042
Area
043
Area
044
Area
045
Area
046
Area
047
Area
048
7 Area
049
Area
050
Area
051
Area
052
Area
053
Area
054
Area
055
Area
056
8 Area
057
Area
058
Area
059
Area
060
Area
061
Area
062
Area
063
Area
064
Door Groups
To access the door group programming login using a valid master code and then select [MENU, 2, 4]. The
screen displays "Door Group to modify" as shown in the following example.
Door Group to
modify: DG001
Every time you press the [ENTER] key, the next screen appears. The different screens are described in the
following sub-sections. Programming the door groups in the Protege System allow you to configure the doors
assigned to a users access level.