Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 335
Test report
time: 02:00
The cursor will be located on the first digit of the hour field. Press the [1] key to program the first digit followed
by the [5], [3] and [0]. The display will now show 15:30 on the screen as below.
Test report
time: 15:30
The new value will be programmed when the [ENTER] key is pressed or another navigation key is pressed
moving screens.
Hexadecimal Data Entry
Hexadecimal entry is required in only a few key locations however it is an important part of the data entry
process. Use the 0-9 keys for the numerical data portion and the 2 and 3 key to obtain the letters A-F (Press the
2 and 3 keys multiple times to cycle through the available values A, B,C and D, E, F).
Pressing the [STAY] key will set the minimum value, pressing the [FORCE] key will set the maximum value and
pressing the [ARM] will recall the value that was previously set.
Hexadecimal entry can take on any number of digits from 1 up to 32 depending on the location that the
hexadecimal number is being entered. In the following example a number of 21B64C90 is being entered in to
the host id setting in the panel configuration.
Panel host
ID: 00000000
When you enter in to a hexadecimal entry screen the cursor will be located on the first hexadecimal digit that
can be set. For our example the default host id of 00000000 will be replaced with our new host id of 21B64C90.
The arrow keys (left and right) can be used to move the cursor to the desired position in the hexadecimal
number if only one part of the existing value requires modification. For example to program a host id of
00000001 you can right arrow to the last digit and simply press the [1] key to set the digit.
Panel host
ID: 00000000
In the above screen the cursor will be flashing over the first 0 of the 00000000 press the [2] key, the 0 will be
replaced with a 2. The cursor will NOT move to the right automatically you must press the right arrow key.
Repeat the above procedure for the 1 value pressing the right arrow key when done.
Panel host
ID: 21B00000
When entering the B press the [2] key 3 times and the display will show the B at the third position pressing the
right arrow once the B is shown in the display. Repeat the same procedures above for the remainder of the
value.
Panel host
ID: 21B64C90
Press the [ENTER] key to save the value shown.
List Data Entry
List data entry is used through out the Protege System and is styled similar to the drop down combination
boxes you find in most computer systems. Data is presented in a list of selectable values. These values may be
from another programmed record in the system (Schedules as an example) or from a predefined static set of
values (Card Reader Formats as an example).
Pressing the [DISARM] key will set the list data entry to the none selection, pressing the [ARM] will recall the
value that was previously set.