Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 303
Analog Input/Output Expander Trouble Zones
The Analog Input and Output Expanders will report trouble zones from 1 to 8 on the first 32 modules, all
modules above address AE032 will be reported using the default code of 9999.
Zone Number Alarm Code Restore Code Reporting Point Number
AE001:01 UA UH 9999
AE001:02 UA UH 9999
AE001:03 UA UH 9999
AE001:04 UA UH 9999
AE001:05 UA UH 9999
AE001:06 UA UH 9999
AE001:07 UA UH 9999
AE001:08 UA UH 9999
AE002:01 UA UH 9999
| | | | | | |
AE032:08 UA UH 9999
AE033:01 UA UH 9999
| | | | | | |
AE250:08 UA UH 9999
In the above table a reporting code of 9999 indicates that the trouble zone is outside the maximum trouble
zones that can be reported for the module type.
DVAC Surgard Zone
The following tables show the reporting codes for the zones when the DVAC Surgard Reporting format is used.
A DVAC reporting code is the actual code that is transmitted on the DVAC communication line, this code is
more than likely translated by the alarm monitoring receiving unit in to a SIA or similar reporting code. The
associated code is shown in the following table in brackets to help diagnose DVAC reporting data.
The DVAC communication format is extremely limited in the capacity that it can communicate and therefore a
large number of zones are group on to a maximum zone number when reported. This limitation is due to the
capacity of the DVAC protocol.
Control Panel Zones
The control panel will report all zones from 1 to 16 using any of the available table configurations.
Zone Number Alarm Code Restore Code Reporting Point Number
CP001:01 09 (BA) 89 (BR) 0001
CP001:02 09 (BA) 89 (BR) 0002
CP001:03 09 (BA) 89 (BR) 0003
CP001:04 09 (BA) 89 (BR) 0004
CP001:05 09 (BA) 89 (BR) 0005
CP001:06 09 (BA) 89 (BR) 0006
CP001:07 09 (BA) 89 (BR) 0007