Specifications

282 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Reporting Tables
Reporting tables are used to map a specific zone range to a reporting point number to allow the Protege to
report the higher zone numbers used within the system over protocols that are limited in the point capacity such
as Contact ID.
A reporting table is also provided for the SIA protocol to correctly display the number of a zone or trouble zone
that is reported.
Contact ID Standard Zones
The following tables show the reporting codes for the zones when the Contact ID Standard Table is used (Table
000, Default). The standard table is ideally suited to small burglary and access control installations.
Control Panel Zones
The control panel will report all zones from 1 to 16 using any of the available table configurations.
Zone Number Contact ID Code Reporting Point Number
CP001:01 130 (Burglary) 001
CP001:02 130 (Burglary) 002
CP001:03 130 (Burglary) 003
CP001:04 130 (Burglary) 004
CP001:05 130 (Burglary) 005
CP001:06 130 (Burglary) 006
CP001:07 130 (Burglary) 007
CP001:08 130 (Burglary) 008
CP001:09 130 (Burglary) 009
CP001:10 130 (Burglary) 010
CP001:11 130 (Burglary) 011
CP001:12 130 (Burglary) 012
CP001:13 130 (Burglary) 013
CP001:14 130 (Burglary) 014
CP001:15 130 (Burglary) 015
CP001:16 130 (Burglary) 016
In the above table a reporting code of 999 indicates that the zone is outside the maximum zones that can be
reported in some cases the zone number will reflect the module address that the zone was activated from to aid
in service.