Specifications

260 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Modem Country Selection
The onboard modem must be configured for the region that the System Controller is being installed in to ensure
proper operation.
Modem Country
NZ/Aus
Use the [1] and [3] keys to scroll the modem country selection until reach the required country and press
[ENTER] to proceed. For more information about list control data entry refer to the section List Control Data
Entry (see page 335).
Default Panel Language
The System Controller supports multiple languages on the Keypad and the Serial Event Printers. The language
selected here will be the default language for users who have no language selected and also for any events.
Language
English
Use the [1] and [3] keys to scroll through the language selection until you reach the required language and
press [ENTER] to proceed. For more information about the list control data entry refer to the section List Control
Data Entry (see page 335).
System Controller Restart
To access the system controller restart menu select [MENU, 4, 9, 3]. The screen will immediately prompt
"Press [ENTER] to restart panel".
Pressing the [ENTER] key will restart the panel. The keypad that is currently being used will be restarted and will
go offline for a short period of time while the panel restarts. This is part of normal operation for a panel restart.
Press [ENTER] to
restart panel.
If a panel restart is not required press the [MENU] key to exit and remain logged in or press the [CLEAR] key to
exit and logout.
System Controller Restart in Bios Mode
On the Protege System Controller, Ensure Dip switch 2 is ON
Cycle the power to the Module.
To access the system controller restart menu select [MENU, 4, 9, 4]. The screen will immediately prompt
"Press [ENTER] to restart panel".
Pressing the [ENTER] key will restart the panel in bios mode, which allows firmware updates to be performed.
The keypad that is currently being used will be restarted and will go offline for a short period of time while the
panel restarts. This is part of normal operation for a panel restart.
Press [ENTER] to
restart panel.
If a panel restart is not required press the [MENU] key to exit and remain logged in or press the [CLEAR] key to
exit and logout.