Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 25
Access Level 1 End Date
Setting the access level end date will disable the access level for this user at 23:59 on this date. If a end time
is also set the access level will be disabled at that time on this date.
UN00001 Axs1 End
date: --/--/----
Use the numerical keys to enter a valid date and then press [ENTER] to program the date. If you do not
program a time in the following section the access level will expire at midnight on the date that is programmed.
For more information about entering the date information refer to the section Date and Time Data Entry (see
page 334).
If you do not enter a valid date an error message will be shown, pressing the [STAY] key will allow you to clear
your entry or set the default value.
Access Level 1 End Time
Setting the access level end time will disable the access level for the user once this time has past. If both the
end time and date are set then the access level will be disabled after the date and time has past. If only the
time is set then the access level will be disabled after this time has past.
UN00001 Axs1 End
time: --:--
Use the numerical keys to enter a valid time in a 24HR format and then press [ENTER] to program the time. If
you do not program a time in the following section the user will expire at midnight on the date that is
programmed. For more information about entering the date information refer to the section Date and Time Data
Entry (see page 334).
If you do not enter a valid time an error message will be shown, pressing the [STAY] key will allow you to clear
your entry.
Access Level 2,3 and 4
Each user can be assigned up to four access levels. Each of these access levels has an independent start and
end time. These are programmed after Access Level 1. Leave the access level as None to disable it.
User Area
The user area can be used to disarm the selected area automatically on login to a keypad or when access is
granted at a door or reader. For this feature to operate correctly the programmed area must belong to the
user's disarm area group. This feature is ideal for securing many individual offices yet arming all of them when all
employees exit and disarming only the person's office that they are allowed to access while other offices remain
secure and protected.
UN00001 Area
None
Use the [1] and [3] keys to scroll the user area selection and press [ENTER] to select the area that is displayed.
For more information about the list control data entry refer to the section List Control Data Entry (see page 335).