Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 249
To modify the Input register (00001 to 65535), use the keypad as explained in section Entering Decimal
Numbers (see page 333) and press [ENTER].
Output Register
This is the register to which the output is directed. It would typically be assigned to a physical analogue output
module.
FN001 Output
reg: 00001
To modify the Output register (00001 to 65535), use the keypad as explained in section Entering Decimal
Numbers (see page 333) and press [ENTER].
Compare Register Base
This is the first register in a sequence of registers which will contain the values to which the input is compared.
FN001 Comp base
reg: 00001
To modify the base Compare register (00001 to 65535), use the keypad as explained in section Entering
Decimal Numbers (see page 333) and press [ENTER].
Output Register Base
For every compare value register there must be an output value register. If the input matches the compare value
then the corresponding output value is copied to the out put register.
FN001 O/P base
reg: 00001
To modify the base Output register (00001 to 65535), use the keypad as explained in section Entering Decimal
Numbers (see page 333) and press [ENTER].
Number of Points
This defines the number of registers starting from the Compare Register Base which will be checked as the
input profile.
FN001 Number of
points: 004
To modify the Number of Points (001 to 032), use the keypad as explained in section Entering Decimal Numbers
(see page 333) and press [ENTER].
Update Rate
Select an Update time. This is the number of seconds between the update of the output register.
FN001 Update
time: 00005 secs
To modify the Update time (00001 to 65535 seconds), use the keypad as explained in section Entering Decimal
Numbers (see page 333) and press [ENTER].