Specifications

214 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
OFF ON ON
ON ON OFF
Input One PGM / Memory Register
Input one selects the input source to the logic process that is being configured. All logic control functions use at
least one input source. Input one must be programmed with a valid input source, if an input source is selected
that is not valid when the function is started an error will be generated and the function suspended. An input
source can be a PGM (Programmable Output) or a Memory Register.
FN001 Input one
pgm: --000:00
To modify the input PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
336).
Input Two PGM / Memory Register
Input two selects the input source to the logic process that is being configured when two inputs are used to
obtain a output. An input source can be a PGM (Programmable Output) or a Memory Register.
FN001 Input two
pgm: --000:00
To modify the input PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
336).
Output PGM / Memory Register
Output PGM selects the PGM output to activate or deactivate as a result of the action being performed by the
logic process.
FN001 Output
pgm: --000:00
To modify the output PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
336).
Area Control Function
To program the area control function ensure that the function you have selected is halted. Select the function
type selection screen as shown below for Area Control.
FN001 Func Type
Area Control
Use the [1] and [3] keys to scroll the function types until you reach the area control selection and press [ENTER]
to select the function type displayed and proceed to the next programmable option for the area control function.
For more information about the list control data entry refer to the section List Control Data Entry (see page 335).
Function Mode
The function mode determines how this function operates with the system controller. By default a function is set
to normal operation. Normal operation will mean the function is started if it was running when the system
restarts or is completely powered down (AC Failure and Battery Failure). The Run Once mode of operation will
allow the function to run once and then wait to be stopped and started by the user or operator.
FN001 Func Mode
Normal
Use the [1] and [3] keys to scroll the function mode until you reach the normal selection and press [ENTER] to
proceed to the next programmable option for the area control function. For more information about the list
control data entry refer to the section List Control Data Entry (see page 335).