Specifications

194 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
PGM Mapping Count
The PGM Mapping count defines the number of PGM's that are mapped between the 2 controllers. This count
can extend past modules, refer to the PGM addressing to work out the addressing of PGMs.
SV001 PGM Link
count: 008
Edit the polling time to a value of 10 to 255 seconds, any number below 10 will disable the polling being sent to
the controller. Use the keypad as explained in section Entering Decimal Numbers (see page 333) and press
[ENTER].
Poll OK PGM
The Poll OK PGM defines the PGM that is activated when communication is established between the 2
controllers.
SV001 Poll OK
pgm: CP001:02
To modify the PGM, use the settings as explained in section Entering PGM and PGM Groups (see page 336).
Poll Fail PGM
The Poll Fail PGM defines the PGM that is activated when communication fails between the 2 controllers.
SV001 Poll Fail
pgm: CP001:02
To modify the PGM, use the settings as explained in section Entering PGM and PGM Groups (see page 336).
General Options
The general options define how the service operates.
SV001 General
[--------]
To modify options, use the keypad as explained in section Entering Data Options
(see page 336).
Option 1 - 8 - Reserved
y Reserved do not modify
VizIP DVR IP Alarm Integration
The VizIP DVR IP Alarm Integration Service provides an interface for Protege System Controllers to
communicate to a DVR over IP that has the VizIP IP communication protocol. This service maps PGMs on the
System Controller to the alarm outputs from the DVR, eliminating the need to have physical wiring connections
from the DVR to the Protege System Controller.
To program the VizIP Service ensure that the service that has been selected is halted. Press the [ENTER] key
until the display shows the service type selection screen.
SV001 Ser Type
VizIP DVR
Use the [1] and [3] keys to scroll the service types until you reach the Viz IP selection and press [ENTER]. For
more information about the list control data entry refer to the section List Control Data Entry (see page 335).