Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 193
Primary IP Address
The primary IP address is the IP of the Protege System Controller that is being linked with.
SV001 Pri IP
000.000.000.000
To modify the IP address use the keypad as explained in section Entering Decimal Numbers (see page 333).
Press [ENTER] to save the Octet that is being entered and move to the next Octet or the next screen once all
four have been completed.
Primary Port
The primary port configures the TCP/IP port the two System Controllers will communicate over.
SV001 Primary
port: 09647
To modify the port configuration use the keypad as explained in section Entering Decimal Numbers (see page
333) and Press [ENTER] to save the modified data.
Polling Time
The polling time is set to schedule periodic connections with the other system controller.
SV001 Poll
time: 120 secs
Edit the polling time to a value of 10 to 255 seconds, any number below 10 will disable the polling being sent to
the controller. Use the keypad as explained in section Entering Decimal Numbers (see page 333) and press
[ENTER].
Function
The function defines how the service will operate; it can either send or receive data. When set to Send Data
the controller will inform the second controller of the PGMs being controller. When set to Receive Data the
controller will listen to the secondary controller and update it's PGM status according to the received values.
SV001 Function
Send Data
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
PGM Mapping Start
The PGM mapping start defines the first PGM that is mapped between the 2 controllers.
SV001 Start
pgm: CP001:01
To modify the PGM, use the settings as explained in section Entering PGM and PGM Groups.