Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 187
Communications Port Speed
The communications port speed defines the baud rate at which the GSM Modem operates. The default value is
9600 bits per second and we recommend that this is not changed. If the speed or configuration is different
adjust this setting to suit the type of modem that is connected however the majority of modems will default to
9600. If you are not sure about the connection speed verify the modem operation using a terminal program
such as (Terraterm or Hyperterminal).
SV001 Speed
9600
Use the [1] and [3] keys to scroll the communication port speed options and press [ENTER] to select the speed
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
Communications Port Parity
The communications port parity defines the parity configuration for the communication with the GSM Modem.
This should not be changed from default.
SV001 Parity
No Parity
Use the [1] and [3] keys to scroll the communication parity options and press [ENTER] to select the parity
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
Data Options
The data configure various communication settings that affect the operation of the Intercom Interface protocol.
SV001 Data
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 336).
Option 1 – Log Modem Communication Events
y Enabled the service will log communication events that occur.
y Disabled the communication events will not be logged.
Option 2,3,4,5,6,7 and 8 - Reserved
y Reserved do not modify
Report IP Service
The Report IP Service allows the Protege System controller to send alarm and activation information over an IP
connected network. The Report IP Service supports multiple formats and allows the connection to third party
reporting if required.
To program the Report IP Service ensure that the service that has been selected is halted. Press the [ENTER]
key until the display shows the service type selection screen.
SV001 Ser Type
Report IP
Use the [1] and [3] keys to scroll the service types until you reach the Report IP selection and press [ENTER].
For more information about the list control data entry refer to the section List Control Data Entry (see page 335).