Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 181
PCI Fail Time
The PCI fail time allows a timer to be triggered on each successful request from the C-Bus Clipsal PCI Interface.
When this timer expires the system will perform a check to see if the PCI is still present and then activate the fail
PGM output if a response is not received.
SV001 PCI fail
time: 120 secs
To modify the fail time (000 to 255, a setting of 000 will result in the default of 120 seconds being used), use the
keypad as explained in section Entering Decimal Numbers (see page 333) and press [ENTER].
i
If the PCI fails to reply to a command or does not send information within the poll fail time the service
will go in to a retry mode where it will continually attempt to restart the PCI. This allows recovery of the
PCI from a power failure or from being used and reconfigured during a C-Bus Programming session.
PCI Fail PGM Output
The PCI fail output is activated if the PCI is disconnected and the system does not get a valid response to a
command. The PGM is deactivated when a valid command is received.
SV001 PCI fail
pgm: --000:00
To modify the PCI fail PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
336).
Intercom High Level Interface
To program the Intercom High Level Interface service ensure that the service that has been selected is halted.
Press the [ENTER] key until the display shows the service type selection screen.
SV001 Ser Type
Intercom
Use the [1] and [3] keys to scroll the service types until you reach the Intercom selection and press [ENTER]. For
more information about the list control data entry refer to the section List Control Data Entry (see page 335).
Service Mode
The service mode determines how this service operates with the system controller. By default a service is set to
start with the operating system. Setting a service to "Start With The Operating System" (Start With O/S) allows
the service to operate automatically, if the system controller is reset or restarts. Manual control of the service
can be set by using the Manual option for the service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).